route -- kernel packet forwarding database
#include <sys/types.h> #include <sys/time.h> #include <sys/socket.h> #include <net/if.h> #include <net/route.h>
int socket(PFROUTE, SOCKRAW, int family);
FreeBSD provides some packet routing facilities. The kernel maintains a routing information database, which is used in selecting the appropriate network interface when transmitting packets.
A user process (or possibly multiple co-operating processes) maintains this database by sending messages over a special kind of socket. This supplants fixed size ioctl(2)'s used in earlier releases.
Routing table changes may only be carried out by the super user. The operating system may spontaneously emit routing messages in response to external events, such as receipt of a re-direct, or failure to locate a suitable route for a request. The message types are described in greater detail below.
Routing database entries come in two flavors: for a specific host, or for all hosts on a generic subnetwork (as specified by a bit mask and value under the mask. The effect of wildcard or default route may be achieved by using a mask of all zeros, and there may be hierarchical routes.
When the system is booted and addresses are assigned to the network interfaces, each protocol family installs a routing table entry for each interface when it is ready for traffic. Normally the protocol specifies the route through each interface as a ``direct'' connection to the destination host or network. If the route is direct, the transport layer of a protocol family usually requests the packet be sent to the same host specified in the packet. Otherwise, the interface is requested to address the packet to the gateway listed in the routing entry (i.e. the packet is forwarded).
When routing a packet, the kernel will attempt to find the most specific route matching the destination. (If there are two different mask and value-under-the-mask pairs that match, the more specific is the one with more bits in the mask. A route to a host is regarded as being supplied with a mask of as many ones as there are bits in the destination). If no entry is found, the destination is declared to be unreachable, and a routing-miss message is generated if there are any listeners on the routing control socket described below.
A wildcard routing entry is specified with a zero destination address value, and a mask of all zeroes. Wildcard routes will be used when the system fails to find other routes matching the destination. The combination of wildcard routes and routing redirects can provide an economical mechanism for routing traffic.
One opens the channel for passing routing control messages by using the socket call shown in the synopsis above:
The family parameter may be AF_UNSPEC which will provide routing information for all address families, or can be restricted to a specific address family by specifying which one is desired. There can be more than one routing socket open per system.
Messages are formed by a header followed by a small number of sockaddrs (now variable length particularly in the ISO case), interpreted by position, and delimited by the new length entry in the sockaddr. An example of a message with four addresses might be an ISO redirect: Destination, Netmask, Gateway, and Author of the redirect. The interpretation of which address are present is given by a bit mask within the header, and the sequence is least significant to most significant bit within the vector.
Any messages sent to the kernel are returned, and copies are sent to all interested listeners. The kernel will provide the process ID for the sender, and the sender may use an additional sequence field to distinguish between outstanding messages. However, message replies may be lost when kernel buffers are exhausted.
The kernel may reject certain messages, and will indicate this by filling in the rtmerrno field. The routing code returns EEXIST if requested to duplicate an existing entry, ESRCH if requested to delete a non-existent entry, or ENOBUFS if insufficient resources were available to install a new route. In the current implementation, all routing processes run locally, and the values for rtmerrno are available through the normal errno mechanism, even if the routing reply message is lost.
A process may avoid the expense of reading replies to its own messages by issuing a setsockopt(2) call indicating that the SO_USELOOPBACK option at the SOL_SOCKET level is to be turned off. A process may ignore all messages from the routing socket by doing a shutdown(2) system call for further input.
If a route is in use when it is deleted, the routing entry will be marked down and removed from the routing table, but the resources associated with it will not be reclaimed until all references to it are released.
User processes can obtain information about the routing entry to a specific destination by using a RTM_GET message, or by calling sysctl(3)?.
struct rt_msghdr {
u_short rtm_msglen; /* to skip over non-understood messages / u_char rtm_version; / future binary compatibility / u_char rtm_type; / message type / u_short rtm_index; / index for associated ifp / int rtm_flags; / flags, incl. kern & message, e.g. DONE / int rtm_addrs; / bitmask identifying sockaddrs in msg / pid_t rtm_pid; / identify sender / int rtm_seq; / for sender to identify action / int rtm_errno; / why failed / int rtm_use; / from rtentry / u_long rtm_inits; / which metrics we are initializing / struct rt_metrics rtm_rmx; / metrics themselves */
};
struct if_msghdr {
u_short ifm_msglen; /* to skip over non-understood messages / u_char ifm_version; / future binary compatibility / u_char ifm_type; / message type / int ifm_addrs; / like rtm_addrs / int ifm_flags; / value of if_flags / u_short ifm_index; / index for associated ifp / struct if_data ifm_data; / statistics and other data about if */
};
struct ifa_msghdr {
u_short ifam_msglen; /* to skip over non-understood messages / u_char ifam_version; / future binary compatibility / u_char ifam_type; / message type / int ifam_addrs; / like rtm_addrs / int ifam_flags; / value of ifa_flags / u_short ifam_index; / index for associated ifp / int ifam_metric; / value of ifa_metric */
};
struct ifma_msghdr {
u_short ifmam_msglen; /* to skip over non-understood messages / u_char ifmam_version; / future binary compatibility / u_char ifmam_type; / message type / int ifmam_addrs; / like rtm_addrs / int ifmam_flags; / value of ifa_flags / u_short ifmam_index; / index for associated ifp */
};
struct if_announcemsghdr {
u_short ifan_msglen; /* to skip over non-understood messages / u_char ifan_version; / future binary compatibility / u_char ifan_type; / message type / u_short ifan_index; / index for associated ifp / char ifan_name[IFNAMSIZ?; / if name, e.g. "en0" / u_short ifan_what; / what type of announcement */
};
The RTM_IFINFO message uses a ifmsghdr header, the RTM_NEWADDR and RTM_DELADDR messages use a ifamsghdr header, the RTM_NEWMADDR and RTM_DELMADDR messages use a ifmamsghdr header, the RTM_IFANNOUNCE message uses a ifannouncemsghdr header, and all other messages use the rt_msghdr header.
The ``struct rt_metrics'' and the flag bits are as defined in rtentry(9)?.
sysctl(3)?, route(8), rtentry(9)?
A PF_ROUTE protocol family first appeared in 4.3BSD-Reno.
No page links to route(4).
