Differences between version 4 and revision by previous author of LinuxWiredCountryNotes.
Other diffs: Previous Major Revision, Previous Revision, or view the Annotated Edit History
| Newer page: | version 4 | Last edited on Thursday, August 19, 2004 3:00:59 pm | by PerryLorier | Revert |
| Older page: | version 2 | Last edited on Thursday, August 19, 2004 2:41:40 pm | by JeremyArnold | Revert |
@@ -6,25 +6,22 @@
This is not complete, but I will work on it as things progress
Details:
-
* Region: Auckland
-
* Flava's
: Debian, m0n0wall (freeBSD), XP (flatmates...)
-
* Gear: Wired Country IDL (Network adaptor, goes to antenna), Cisco ATA188 (uplinks to IDL, outputs Ethernet, 2x VoIP phones)
+* Region: Auckland
+* Flavourrs
: Debian, m0n0wall (freeBSD), XP (flatmates...)
+* Gear: Wired Country IDL (Network adaptor, goes to antenna), Cisco ATA188 (uplinks to IDL, outputs Ethernet, 2x VoIP phones)
It appears that the IDL will only give out 1 (one) DHCP lease, so if you want to connect a machine you need to power down the gear, connect the machine and power the gear backup to clear the lease table... If you don't power down the gear you wont be able to connect from any machine except that connected at first power up.. took me 3 days to find this out O_o
Powering down the Gear:
IDL: just unplug the power ??
ATA188: disconnect ethernet cables (both link and uplink), wait 20 sec, unplug power. (from Cisco 186 user manual - GoogleIt)
Powering up the Gear:
-Step 1:
Connect IDL Power
-Step 2:
Wait a while
-Step 3:
Conect ATA188 ethernet cables then power....
-
-
-
-Step 4:
check dial tone.
-Step 5:
Connect via PPPoE (if your computer hasnt already)
+#
Connect IDL Power
+#
Wait a while
+#
Conect ATA188 ethernet cables then power.... If ATA188 light keeps flashing for longer than 20sec or so, unplug power for a few seconds
+#
check dial tone.
+#
Connect via PPPoE (if your computer hasnt already)
More to follow ....
