Differences between current version and predecessor to the previous major change of Baytech_RPC_3_serial_cable.
Other diffs: Previous Revision, Previous Author, or view the Annotated Edit History
| Newer page: | version 2 | Last edited on Monday, September 10, 2007 3:45:43 pm | by AristotlePagaltzis | |
| Older page: | version 1 | Last edited on Sunday, August 26, 2007 5:47:17 pm | by KevinGeorge | Revert |
@@ -1,26 +1 @@
-The
Baytech RPC-
3 is a
serial/ethernet controlled 8 outlet remote power controller. Using the serial port or 'telnet', you can turn each electrical outlet on and off. Initial configuration has to happen using it's serial port. So you'll need a
cable like the one described
here to set it up.
-
-Required connections for a Baytech RPC-3 RJ45 to DB9 null modem serial cable:
-
-<pre>
-rj45 db9 serial
-pin pin
-==========================================================
-4 2 (rpc-3 TX -> pc RX)
-5 3 (rpc-3 RX -> pc TX)
-3 8 (rpc-3 RTS -> pc CTS)
-1 6 (rpc-3 DTR -> pc DSR)
-2 5 (GND to GND)
-8 1 (rpc-3 carrier detect -> carrier present)
-</pre>
-
-Pins 6 and 7 on the RJ45 side can remain disconnected, along with
-pins 4, 7 and 9 on the DB9 side.
-
-Tested and working on an RPC-3 using a usb->serial adapter.
-
-Based on:
-* rpc-3 manual word document
-* http://www.loop-back.com/rs232_std.html
-* http://www.loop-back.com/null-mod.html
-* http://www.arduino.cc/en/uploads/Tutorial/DB9-pinout
.gif
+Describe [
Baytech_
RPC_
3_
serial_
cable]
here.
