Sample zebra.conf
hostname hostname(1) password YourVTYPassword enable password !YourEnablePassword? log file /var/log/zebra/zebra.log interface lo
ipv6 nd suppress-ra
interface eth0
ipv6 nd suppress-ra
interface sit0
ipv6 nd suppress-ra
use tap0 if using ETHERTAP, or wan0 if using TUN
interface tap0
interface wan0
ipv6 nd suppress-ra
interface ppp0
ipv6 nd suppress-ra
line vty
allows you to configure Zebra via a telnet connection to localhost? on port 2601 (zebra), requires password set
If you dont have IPv6 Support, you will need to remove the ipv6 lines
To get SNMP working with Zebra, refer to ZebraSNMP
2 pages link to zebra.conf: