View Source: zebra.conf - Waikato Linux Users Group

You are viewing an old revision of this page. View the current version.

 hostname hostname(1)
 password YourVTYPassword
 enable password YourEnablePassword
 log file /var/log/zebra/zebra.log
 interface lo
  ipv6 nd suppress-ra
 interface eth0
  ipv6 nd suppress-ra
 interface sit0
  ipv6 nd suppress-ra
 interface tap0
  ipv6 nd suppress-ra
 interface ppp0
  ipv6 nd suppress-ra
 !smux peer .1.3.6.1.4.1.3317.1.2.1 %%%
 ! not sure if smux is necessary, mine works without it even though I spend hours trying to get it working
 ! smux is "SNMP Multiplexer" it lets you query the routing daemon, but requires a SNMP daemon to be running (hence why you may see smux "errors")
 line vty %%%
 ! allows you to configure zebra via a telnet connection to localhost on port 2601 (zebra), requires password set

''If you dont have IPv6 Support, you will need to remove the ipv6 lines ''

2 pages link to zebra.conf:

Version 1, saved on Tuesday, July 23, 2002 7:17:30 am by CraigMckenna

Edit PageHistory Diff Info LikePages