SWAPON
NAME SYNOPSIS DESCRIPTION PRIORITY RETURN VALUE ERRORS CONFORMING TO NOTES SEE ALSO
swapon, swapoff - start/stop swapping to file/device
#include
int swapon(const char *path, int swapflags__); int swapoff(const char
swapon sets the swap area to the file or block device specified by path. swapoff stops swapping to the file or block device specified by path.
swapon takes a swapflags argument. If swapflags has the SWAP_FLAG_PREFER bit turned on, the new swap area will have a higher priority than default. The priority is encoded as:
(prio
These functions may only be used by the super-user.
Each swap area has a priority, either high or low. The default priority is low. Within the low-priority areas, newer areas are even lower priority than older areas.
All priorities set with swapflags are high-priority, higher than default. They may have any non-negative value chosen by the caller. Higher numbers mean higher priority.
Swap pages are allocated from areas in priority order, highest priority first. For areas with different priorities, a higher-priority area is exhausted before using a lower-priority area. If two or more areas have the same priority, and it is the highest priority available, pages are allocated on a round-robin basis between them.
As of Linux 1.3.6, the kernel usually follows these rules, but there are exceptions.
On success, zero is returned. On error, -1 is returned, and errno is set appropriately.
Many other errors can occur if path is not valid.
EPERM
The user is not the super-user, or more than MAX_SWAPFILES (defined to be 8 in Linux 1.3.6) are in use.
EINVAL
is returned if path exists, but is neither a regular path nor a block device.
ENOENT
is returned if path does not exist.
ENOMEM
is returned if there is insufficient memory to start swapping.
These functions are Linux specific and should not be used in programs intended to be portable. The second `swapflags' argument was introduced in Linux 1.3.2.
The partition or path must be prepared with mkswap(8).
mkswap(8), swapon(8), swapoff(8)
3 pages link to swapon(2):