The mcd command is used to change the mtools working directory on the MS-DOS disk. It uses the following syntax:
Without arguments, mcd reports the current device and working directory. Otherwise, mcd changes the current device and current working directory relative to an MS-DOS filesystem.
The environmental variable MCWD may be used to locate the file where the device and current working directory information is stored. The default is `$HOME/.mcwd'. Information in this file is ignored if the file is more than 6 hours old.
Mcd returns 0 on success or 1 on failure.
This manpage has been automatically generated from mtools's texinfo documentation. However, this process is only approximative, and some items, such as crossreferences, footnotes and indices are lost in this translation process. Indeed, these items have no appropriate representation in the manpage format. Moreover, not all information has been translated into the manpage version. Thus I strongly advise you to use the original texinfo doc. See the end of this manpage for instructions how to view the texinfo doc.
To generate a printable copy from the texinfo doc, run the following commands:
./configure; make dvi; dvips mtools.dvi
To generate a html copy, run:
To generate an info copy (browsable using emacs' info mode), run:
./configure; make info