Penguin

BDFLUSH

BDFLUSH


NAME

bdflush - start, flush, or tune buffer-dirty-flush daemon

SYNOPSIS

int bdflush(int func, long *address); int bdflush(int func, long data);

DESCRIPTION

bdflush starts, flushes, or tunes the buffer-dirty-flush daemon. Only the super-user may call bdflush.

If func is negative or 0, and no daemon has been started, then bdflush enters the daemon code and never returns.

If func is 1, some dirty buffers are written to disk.

If func is 2 or more and is even (low bit is 0), then address is the address of a long word, and the tuning parameter numbered (func-2)/2 is returned to the caller in that address.

If func is 3 or more and is odd (low bit is 1), then data is a long word, and the kernel sets tuning parameter numbered (func-3)/2 to that value.

The set of parameters, their values, and their legal ranges are defined in the kernel source file fs/buffer.c.

RETURN VALUE

If func is negative or 0 and the daemon successfully starts, bdflush never returns. Otherwise, the return value is 0 on success and -1 on failure, with errno set to indicate the error.

ERRORS

EPERM
Caller is not super-user.
EFAULT
address points outside your accessible address space.
EBUSY
An attempt was made to enter the daemon code after another process has already entered.
EINVAL
An attempt was made to read or write an invalid parameter number, or to write an invalid value to a parameter.

CONFORMING TO

bdflush is Linux specific and should not be used in programs intended to be portable.

SEE ALSO

fsync(2), sync(2), update(8), sync(8)?

This page is a man page (or other imported legacy content). We are unable to automatically determine the license status of this page.