apcsmart should recognize all APC models that use a serial protocol at 2400 bps. This is primarily the Smart-UPS and Matrix-UPS lines, but some Back-UPS Pro models are also supported.
This driver expects to see a 940-0024C cable or a clone by default. You can switch to the 940-0095B dual-mode cable support with the cable= definition described below.
If your 940-0024C cable is broken or missing, use this diagram to build a clone:
This driver supports the following optional values for -x and in the ups.conf(5):
Configure the serial port for the APC 940-0095B dual-mode cable.
Use shutdown type num, according to this table:
0: soft shutdown or powerdown, depending on battery status
1: soft shutdown followed by powerdown
2: instant power off
3: power off with grace period
The core driver:
The NUT (Network UPS Tools) home page: http://www.exploits.org/nut/
lib/main.php:944: Notice: PageInfo: Cannot find action page