Penguin
Recent Changes
Annotated edit history of PSU version 12, including all changes. View license author blame.
Rev Author # Line
10 JohnMcPherson 1 [Acronym] for __P__ower __S__upply __U__nit.
2
3 Generally, the bit that takes 240v AC and turns it into the various levels required inside the computer.
4
5 [PSU]s can range from 1.5 volt wall-warts (those little black boxes intended to hang out of a wall power supply) right up. The biggest power supply I have is a two part unit, with a single phase rectifier and then a 440 volt PSU for an ancient photograph enlarger, which was used in printing photographs to paper.
6
11 SimonVanderVeken 7 PC power supplies range in quality from a $50 taiwanese crapper to a $500 Lian-li or seventeam or antar item.
10 JohnMcPherson 8
11 SimonVanderVeken 9 The differences come from:
10
11 * Max sustained loading (a running PC uses between 20 and 600 watts of power)
10 JohnMcPherson 12 * Max peak loading (the quoted Wattage on the label)
11 SimonVanderVeken 13 * Resilience to voltage dips on load changes
10 JohnMcPherson 14 * Current levels on each power rail
11 SimonVanderVeken 15 * Resilience to current dips on load changes
10 JohnMcPherson 16 * Heat production
17 * Noise production
18
19 There are a rats-nest of wires coming out of a PSU. There are large and small four-pin connectors intended for drives. These are called [Berg] connectors[1], and carry +5V, +12V and two ground wires.
20
21 PSUs for computers these days are [ATX] which means they have a unique 20 pin motherboard connector. [ATX] PSUs for Pentium 4 and other recent motherboards have two more connectors to provide 12V and ground to the [CPU]. The cool thing about [ATX] is that the power switch is only 12V and is connected to the mainboard, not the [CPU]. Because [ATX] power supplies are always on, they always supplies a low current to the mainboard in ATX, so don't change ram or IO cards or CPUs without unplugging the mains first. This latter is also a disadvantage as the case and system are no longer grounded to earth through your power cord, so you have to be very carefull with statically sensitive equipment (in case of a computer, everything but the physical chassis/case is a good guideline).
12 IanMcDonald 22
23 Newer PSUs are certified as [ATX] and [BTX] compatiable. The pin layout for [BTX] appears to be the same as [ATX].
10 JohnMcPherson 24
25 Older PSUs are often [AT], in which there are a pair of motherboard connectors, which are almost always labelled P8 and P9. Sometimes a third connector is present for multi-CPU machines. The biggest irritation for [AT] PSUs is that the power switch is a 240V switch, and is wired to the PSU. An advantage of this is if you turn the computer off, it is off. A disadvantage is that changing the PSU can get fiddly near the power switch, and if you have a dodgy switch may cause a bit of a shock.
26
27 Note - [Compaq], [Dell], and [Gateway] are renowned for using strange PSU standards.[2][3] If you need to replace a PSU in one of those brands then check very carefully. The good news is that the stock PSU is very well engineered. In some cases with these types of machines, it may end up that replacing the case and PSU is a cheaper alternative (as in the case of most [Gateway] computers).
28
29 Some cards have power connectors on them too - I've seen an ancient [MFM] hard drive controller and a modern FireWire card and a modern [SATA] controller with Berg connectors for power. Presumably these cards would draw too much current from the [ISA] or [PCI] bus.
30
31 ----
32 [1] More commonly known as Molex connectors after their inventor/manufacturer
33
11 SimonVanderVeken 34 [2] In the case of Dell PSU's it's possible that they've 'shifted' one (or more?) wires from the ATX connector to one of the other connectors. So in theory it should be possible to hack a 'normal' PSU and turn it into a 'Dell' PSU :) Probably not worth the bother though. According to other sites, models from the Dimension 8250 up use standard ATX PSUs, so replacement of these models is fairly straightforward.
10 JohnMcPherson 35
36 [3] Another problem with these [PSU]'s is that they could (possibly) have non-standard sizes/dimensions. A standard [PSU] will probably not fit in a [Dell] or [Gateway] casing.
37
38 ----
39 Part of CategoryHardware