The lmsensors package allows you to check some vital statistics of your motherboard, such as core voltage values, temperature readings and fan speed monitoring. Almost all motherboards since the PentiumII era have had this built on.
For comparison, my 1.1GHz Athlon system has a motherboard temperature of around 44 degrees Celsius and the CPU has a temperature of around 50 degrees Celsius on a warm spring's day. (These might be a tad higher than most people would find acceptable(?), but I don't have any extra case fans, only a fan on the heatsink and the PSU's fan).
LM Sensors are very dependent on your:
This will require you to do nasty things to your machine, such as compile kernels, and possibly require you to get out a screwdriver to open up your machine to look at chips on the motherboard ! Not for the faint hearted !
I'm going to go over how I got it going on my motherboard, my kernel, and with Debian Woody. Add your experiances if they are different.
There are a number of steps to go through to get it going.
Gigabyte AMD boards (via southbridge based boards)
with some gigabyte boards (and possibly others), the module load order is important 7ZM (Socket A) requires that you load the modules in the order i2c-isa i2c-viapro via686a <-- the chip driver to via southbridge boards
you may also want to load i2c-proc and i2c-dev if you havnt built them into the kernel
I knew to use the it87 module and config from the above notes, but if I didn't, I would have looked at my motherboard's manual, for example, .
to /etc/modules.conf so that the module uses different calculations. If you really want to know how I derived that option, read /usr/share/doc/lm-sensors/doc/chips/it87.gz (in debian, at least).
Here's a link to my /etc/sensors.conf file.
On an Abit KT7 motherboard, the chip is a "via686b" - you need to use the "via686a" driver. See the sensors.conf file for my setup for this.
If you have a Dell server which you're wanting to use lm-sensors with, you're a bit out of luck. Dell motherboards do indeed have LM87 chips, but they are behind some fancy thingy, meaning only Dell software can access them (Dell OpenManage Server Administrator).
quote from a Dell employee; 'There are LM78's, but they are behind our own "inteligent" interface(uP). So the bad news is that lmsensors can't talk to PE servers sensors. The good news is that our systems management group has ported the software to allow access to all of this great info via SNMP. It even supports our older PE servers that only have TVM sensors (LM78's). It's actually a nice package, you can even re-Flash your BIOS from linux.'
The software to monitor via SNMP can be found at http://linux.dell.com/files/openmanage-contributions/debian/. If installing on Debian (woody?), you'll need to install v4.7.1 first (http://linux.dell.com/files/openmanage-contributions/debian/dellomsa_4.71-3653_i386.deb and http://linux.dell.com/files/openmanage-contributions/debian/dellomsa-drivers_4.71-3653_i386.deb) then v4.90 (or the program part of 4.90 at least, the 4.90 drivers didn't work for me so I stuck with 4.71)
lib/main.php:944: Notice: PageInfo: Cannot find action page