Differences between version 17 and previous revision of LiloErrorCodes.
Other diffs: Previous Major Revision, Previous Author, or view the Annotated Edit History
| Newer page: | version 17 | Last edited on Tuesday, July 19, 2005 12:02:24 pm | by DanielLawson | Revert |
| Older page: | version 16 | Last edited on Tuesday, July 19, 2005 11:59:21 am | by DanielLawson | Revert |
@@ -19,9 +19,9 @@
|0x11|__[ECC] correction successful__: A read error occurred, but was corrected. LILO does not recognize this condition and aborts the load process anyway. A second load attempt should succeed.
|0x20|__Controller error__: This shouldn't happen, then again, none of these errors should happen eh?
|0x40|__Seek failure__: This might be a media problem. Try booting again.
|0x80|__Disk timeout__: The disk or the drive isn't ready. Either the media is bad or the disk isn't spinning. If you're booting from a floppy, you might not have closed the drive door. Otherwise, trying to boot again might help.
-|0x99|__Invalid Second Stage__: Mismatch between drive and BIOS geometry, or a bad map file. Some evidence that 'Linear' needs to be set on the disk (see below)
+|0x99|__Invalid Second Stage__: Mismatch between drive and BIOS geometry, or a bad map file. Some evidence that 'Linear' needs to be set on the disk (see [
below|http://www.wlug.org.nz/LiloErrorCodes#hdr_notes_on_linear_mode]
)
|0xBB|__BIOS error__: This shouldn't happen. Try booting again. If the problem persists, removing the COMPACT option or adding/removing LINEAR or LBA32 might help.
?>
