Annotated edit history of
ALE070 version 6 showing authors affecting page license.
View with all changes included.
| Rev |
Author |
# |
Line |
| 1 |
RichardBarrington |
1 |
The Dynalink ALE070 is a USB connected modem with a ~GlobeSpan Virata chipset. Fortunately, this chipset is fairly well supported by the ECIADSL project, and this modem has been used successfully overseas. |
| |
|
2 |
|
| 5 |
RichardBarrington |
3 |
* Dynalink ALE070 product page - http://www.dynalink.co.nz/products/ale070.htm |
| |
|
4 |
* ECIADSL project - http://eciadsl.flashtux.org/index.php?lang=en %%% |
| |
|
5 |
* ECIADSL ALE070 support status - http://eciadsl.flashtux.org/modems.php?modem=27 |
| 1 |
RichardBarrington |
6 |
|
| |
|
7 |
The documentation is quite thorough, and setup doesn't take long. Binaries are available for many distributions. |
| |
|
8 |
|
| |
|
9 |
!! [Ubuntu] 5.04 installation from source |
| |
|
10 |
* Ensure gcc(1), make(1), and similar are installed |
| |
|
11 |
* Install kernel headers with <code>apt-get install kernel-headers-2.6.10-5</code> |
| |
|
12 |
* Download the source archive with <code>wget http://eciadsl.flashtux.org/download/eciadsl-usermode-0.10.tar.bz2</code> |
| |
|
13 |
* Extract the archive with <code>tar -jxf eciadsl-usermode-0.10.tar.bz2</code> and then <code>cd eciadsl-usermode-0.10</code> |
| |
|
14 |
* Edit the package control file with <code>vi debian/control</code> and remove the pppoe dependency on line 10 |
| 6 |
SimonWerner |
15 |
* Run <code>dpkg-buildpackage -us -uc -b</code> to build a package |
| 1 |
RichardBarrington |
16 |
* Finally <code>cd ..</code> and install the new package with <code>dpkg -i eciadsl_usermode_0.10.i386.deb</code> |
| |
|
17 |
|
| |
|
18 |
The system can be configured with <code>eciadsl-config-tk</code> |
| |
|
19 |
* Remember to set VPI to 0 and VCI to 100 |
| |
|
20 |
* Use the default synch01.bin |
| |
|
21 |
* Set the [PPP] mode to LLC_RFC2364 |
| |
|
22 |
* Enter your JetStream username and password |
| |
|
23 |
* Save the config |
| |
|
24 |
|
| |
|
25 |
The link can be brought up by running <code>eciadsl-start</code> |
| |
|
26 |
|
| |
|
27 |
Any problems, please refer back to the project website and documentation. |
